Two-Post BendPak lift wired up and ready to work

A two-post lift is only as good as the electrical setup behind it. If the wiring isn't done right, you're looking at tripped breakers, motor burnout, or worse - a safety hazard with thousands of pounds hanging in the air. That's not a risk worth taking.

We got called out to a local dealership to handle the electrical for a BendPak two-post lift install. The lift itself is a serious piece of equipment, and it needed a clean, dedicated power setup to match. We made sure everything was wired to spec - safe, solid, and built to handle the load day in and day out.

While we were there, we knocked out the shop lighting too. A working bay needs real light. Not dim, yellowed fixtures that make it hard to see what you're doing under a vehicle. The shop ceiling got lined out with bright LED shop lights that actually cover the space properly. It changes the whole feel of the bay.

When a shop is wired right, it just runs better. The techs can work faster, the equipment performs like it should, and there's nothing sketchy going on behind the walls. That's what clean commercial electrical work looks like - nothing fancy, just done correctly.

Whether it's powering up new shop equipment or upgrading the lighting in a commercial space, we handle it the same way every time. The right materials, the right approach, no shortcuts.